全國熱線服務(wù):
新聞資訊 Top label
- Fiberglass Composite Air Ducts: Revolutionizing Modern HVAC Systems
- The Complete Guide to Honed Tubes: Precision Engineering for Modern Industry
- Digital pH Sensors: Revolutionizing Industrial Process Control and Environmental Monitoring
- Precision Gas Flow Meters And Mass Flow Controllers: The Ultimate Guide To Technology Selection, Calibration, And Application Optimization For Semiconductor, Pharmaceutical, And Research Processes
- Laser Cutting Technology: Working Principle, Types & Application Guide
- Casting Vs Forging Vs CNC Machining — Decision Framework For Custom Components
A brief analysis of the reasons why piston rods are often damaged
1. It is possible that the process gas contains a large amount of liquid, which causes the impact of the piston rod and the cylinder fluid, causing it to be broken at the dead center gap.
2. The design of the piston rod's buffer, cylinder and cylinder seat is very unreasonable. It may be that the position of the buffer is relatively far from the cylinder, causing the exhaust gas to not be buffered as it should be. As a result, the cylinder begins to vibrate, along with the piston rod. At this time, the concentricity of the piston rod and the crosshead deviates.
3. When installing the cylinder and the middle body, the concentricity did not meet the specified standards, resulting in an angle between the middle lines of the cylinder and the middle body. The piston rod and crosshead can easily cause bending stress during operation.
4. When processing the piston rod thread, the bottom angle of the thread should be set relatively small.
Please indicate the source when reprinting:http://m.hkgz.cn
2. The design of the piston rod's buffer, cylinder and cylinder seat is very unreasonable. It may be that the position of the buffer is relatively far from the cylinder, causing the exhaust gas to not be buffered as it should be. As a result, the cylinder begins to vibrate, along with the piston rod. At this time, the concentricity of the piston rod and the crosshead deviates.
3. When installing the cylinder and the middle body, the concentricity did not meet the specified standards, resulting in an angle between the middle lines of the cylinder and the middle body. The piston rod and crosshead can easily cause bending stress during operation.
4. When processing the piston rod thread, the bottom angle of the thread should be set relatively small.
Please indicate the source when reprinting:http://m.hkgz.cn